Skip to main content
Skip to main content

Kevin Stephan's Successful Thesis Defense in Energy Process Engineering

Warm congratulations to Dr. Kevin Stephan on successfully defending his dissertation and thereby earning his doctorate at the University of Siegen.

Vortrag Kevin Stephan

Kevin Stephan presents his research on the IPV method.

Study of Integrated Pyrolysis and Incineration for Energy-Efficient Sewage Sludge Recovery

As part of his dissertation, Kevin Stephan investigated the energy potential of the integrated pyrolysis and combustion (IPV) process as a gasification method for sewage sludge recovery. The starting point was the requirement—effective for all wastewater treatment plants starting in 2032—to recover phosphorus from sewage sludge, which means that processes involving the separate treatment of sewage sludge are becoming more important compared to co-incineration plants. Since incineration plants generate only heat—which must be used immediately—gasification processes, in which the generated gas can be stored, offer a viable alternative.

To this end, Stephan developed a simulation model of a complete IPV plant. He described the thermochemical conversion processes using thermodynamic property values, energy balances, and empirical correlations. He also adapted the method for minimizing Gibbs free energy to the modeling. Using the model, he calculated the mass and energy flows of the plant and investigated how different process parameters influence its efficiency. A sensitivity analysis showed that higher process temperatures can improve plant efficiency. Stephan demonstrated that, by optimizing operating conditions, combustion temperatures in the range of 850 to 950 °C can be achieved. The heat from the outgoing gas streams can be used to preheat air and superheat the steam. Depending on the parameters, the calculated cold gas efficiency ranged from approximately 58 to 75 percent.

Finally, Stephan compared various potential uses for the generated product gas. Here, the IPV plant achieved an efficiency of 80.8 percent with direct thermal utilization; when upstream sewage sludge drying was included, this figure dropped to 49.6 percent. For a concept focused on electricity generation, in which the separated tars are co-incinerated in the fluidized bed, the values were 72.5 and 44.5 percent, respectively.

Overall, the results show that, depending on the application concept, the IPV process can represent an energy-efficient alternative to conventional mono-incineration in a stationary fluidized bed. This study and the developed model could also serve as a basis for planning an industrial power plant based on the IPV process.